So... how do I select a pair of trousers on this website? In this guide page I will try to help out, with some pictures!

-> How I catalog

Each pair of trousers has been precisely measured, but they are catalogued on the website according to the general size to make it easier to filter. For example, when a trouser has been measured at the waist to be between 39 cm and 41 cm, it will be listed as "EU46/W30". So within this general size, there can be slight differences in precise dimensions per pair. 

-> How I measure

These precise measurements are given for each and every single pair, in the description. This was done in an effort to make it as easy as possible to select a pair that will fit you, since this is an online store and it's not possible to try them on in a physical store before purchase. But of course, small variations can always occur, typically around 1 cm of variance is possible with the measurements provided. This is also because of the sheer amount of stock scanned in.

Below, with the help of some pictures, I show how I take every measurement. This can be used to compare with a pair of trousers you already have that fits you well. 

Waist

This is measured by laying the trousers on a flat surface, and measuring across the waistband. Please ensure this is done whilst keeping the waistband pressed flat, to get the most accurate measurement. 

Front Rise

This is measured from the crotch seam, along the fly, up until the top of the waistband. 

Total Length

This is measured by laying the trousers on their side, and measuring along the entire length. 

Inseam Length

This is measured by laying the trousers on their side, and measuring from the crotch seam along the leg to the bottom. 

Thigh Width

This is measured by folding the trousers open, and measuring about 5 cm below the crotch seam across the leg.

Ankle Width

This is measured by laying the measuring tape flat across the bottom of the leg.

Cuff/Inlay

This is measured as such, by measuring the height of the material.

-> Can anything be altered? (Often) Yes!

So the easiest alteration of all is the length, this can practically always be adjusted. A shorter leg is always possible, a longer one is possible if there is sufficient inlay material. For example, if there is 8 cm of inlay, the trousers can be extended in length by about 6-7 cm.

Waist width can also be adjusted; typically a pair of trousers can be taken in at the waist by a couple sizes without major difficulties. For an even smoother look, one can request the tailor to do this by taking the trousers in at the sides (though this is usually a bit more expensive). The waist can also be let out if there is sufficient inlay, however, usually this permits not more than one size. Taking in or reducing is always easier than enlarging, so when in doubt, it is always advisable to select a pair that might be a little long, or a little wide as there is a higher chance of being able to alter it to your needs. 

Another alteration that can be done is changing the width of the trouser legs. Again, the width can always be reduced, but can only be let out if there is sufficient inlay material present.